STARLINK Flashing Manual page 10

INSTALLATION INSTALLATION
Install Instructions
7. Apply roof cement under shingles and around edge of
mount. Lay shingles back on top and apply pressure
to adhere.
8. Carry Starlink to install location. To prevent damage to the
Starlink, do not set face-down onto the roof.
Never set the Starlink onto roof. Directly place the Starlink into mount.
9A. If routing through attic space: route connected cable
through pre-drilled hole in roof, then go inside and pull
the necessary amount of cable through roof. For any
excess cable on top of the roof, coil and store in the
bottom half of the mount.
9B. If routing cable over the roof: unravel your connected cable
coil and route the loose end into your home.
10. Place the top half previously assembled in Part I to the
lower half of mount. Install 4 tek screws to attach the top
half to the lower half. An undersized pilot hole is present
and some force is needed to start the tek screw. A power
drill is recommended.
11. Place the mast of the Starlink into the hole at the center of
the mount. Mount Starlink within 5° of vertical. Snap buttons
do not need to be depressed when inserting Starlink.
12. Use wall clips to fasten the cable to the wall along your route.
Avoid puncturing cable, sharp bends, and follow horizontal /
vertical lines.
ENGLISH ENGLISH