Operation; Installation And Charging Of Battery Pack - Electro-Voice EVERSE 8 User Manual

20 en | Operation
4

Operation

4.1

Installation and charging of battery pack

The EVERSE 8 comes pre-installed with a high capacity Li-Ion battery pack. Charge the battery
for 24 hours before the first use to ensure maximum battery run time and life expectancy.
To charge the battery:
4
After the first full charge, the expected battery charge times are as follows:
–
–
The LCD will display
LCD will display
Notice!
Battery self-discharge
All Li-Ion batteries experience self-discharge over extended periods (several months). If a
i
battery sits for an extended period without being charged, the battery may fully discharge. It
may take longer than normal to fully recharge. If this occurs, allow the battery to charge a full
24 hours again before using.
Inspect your loudspeaker and battery monthly and recharge the battery. This will help
maintain the batteries run time and extend its useful life.
To remove and reinstall the battery for inspection or replacement:
1.
2.
2022-10 | 02 | F.01U.401.530
Plug the MAINS IN while the battery is installed in the EVERSE 8 .
4 hours or less with no signal and the power switched off.
6 hours or less with the power switched on and audio playing at high output levels.
when the battery has reached full charge.
Place the loudspeaker grille side down with the battery door facing you on a flat non-
scratching surface such as a workbench with a rubber mat.
Fully loosen the two finger tab screws by turning them counter-clockwise.
while the battery is charging with the power switched off. The
User manual
EVERSE 8
Electro-Voice