Electro-Voice EVERSE 8 User Manual page 16

16 en | Description
3.
4.
5.
6.
7.
2022-10 | 02 | F.01U.401.530
Adjust the MASTER VOL knob to 0 dB.
Push the input selection soft key for
INPUT 1 or INPUT 2 if using an XLR or TRS
cable, or push the input selection soft key
for INPUT 3/4 if using 3.5 mm mini jack.
Use the MASTER VOL knob to adjust gain
to MUTE.
Connect an audio source using an XLR or
TRS cable to INPUT 1, INPUT 2, or a
3.5 mm mini jack to INPUT 3/4. Ensure
audio source is MUTE or at a low level
before making connection. After connection
is made, increase the source's output to a
reasonable level.
Adjust the INPUT LEVEL until the signal
peaks are just below maximum level or the
required output is achieved. If CLIP is
indicated, turn the level down until the
CLIP indication disappears.
Press the input selection soft key again to
exit the channel menu.
Adjust the MASTER VOL knob until you get
the required output from the loudspeaker.
INPUT1
INPUT1
User manual
INPUT2
INPUT3/4
INPUT2
INPUT3/4
Electro-Voice
EVERSE 8