Eagle Group RedHots Operating Manual And Instructions

Advertisement

Quick Links

INSTRUCTION SHEET
#361835
CARRIER FOR ANY DAMAGE. SAVE YOUR BOX AND ALL PACKING MATERIALS.
YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.
This manual provides installation and operation instructions for Eagle's RedHots
Light Units. Please read this manual before installing and operating this unit. Personal injury or
damage to the unit can occur if installed or operated incorrectly.
1. This equipment is designed and sold for commercial use only by personnel trained and experienced in its operation and is not sold
for consumer use in and around the home, nor for use directly by the general public in foodservice locations.
2. Do not immerse unit in water.
3. All repairs should be done by an authorized service center.
4. Units should be turned off when not in use. It is recommended that unit be disconnected from power supply by removing plug
receptacle, or by shutting off power supply to the unit.
Eagle Foodservice Equipment, Eagle MHC, and SpecFAB
RedHots
Display Light Units
OPERATING MANUAL AND INSTRUCTIONS
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING
Retain this manual for future reference.
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A.
• Phone: 302/653-3000 • 800/441-8440
• Fax: 302/653-2065 • www.eaglegrp.com
®
CAUTION
IMPORTANT!
CAUTION!
are divisions of Eagle Group. ©2022 by the Eagle Group
®
®
Display
EG10074
revised 07/22

Advertisement

Table of Contents
loading

Summary of Contents for Eagle Group RedHots

  • Page 1 CARRIER FOR ANY DAMAGE. SAVE YOUR BOX AND ALL PACKING MATERIALS. YOU ARE RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED. IMPORTANT! This manual provides installation and operation instructions for Eagle’s RedHots ® Display Light Units. Please read this manual before installing and operating this unit. Personal injury or damage to the unit can occur if installed or operated incorrectly.
  • Page 2: General Notes

    All display light units are shipped completely assembled with field wiring connections and are ready to be mounted. Please see the “Mounting Location” section of this manual for mounting clarification. Eagle Group provides a 7/8˝ and 1 1/8˝ knockout on the switch side of the unit for non-cord &...
  • Page 3: Electrical Requirements

    Following UL, NEC and local codes, install a copper supply wire temperature rated no lower than 90C to the Display Light Unit. Eagle Group supplies a 7/8˝ and 1-1/8˝ knockout on the left side of the aluminum housing and 6˝ long, 12-gauge pigtails with a separate ground screw.
  • Page 4 OPERATING MANUAL AND INSTRUCTIONS MOUNTING LOCATIONS (continued) CHAIN-MOUNTED UNITS (available only with cord & plug connection) Chain supplied by Eagle Group is constructed of sufficient strength to securely hold the weight of the RedHots Display Light Unit ® when properly mounted (ordered separately by the foot under Eagle Group part #358372.) Securely fasten the chain to surface above the area that the display light unit will be located over.
  • Page 5 Remove the top two #8-32 screws on the display light unit on both sides. Align the holes in the bracket to the holes in the display light unit as shown below and securely mount the screws. Secure the display light bracket using #1/4-20 screws (not provided by Eagle Group) to ensure a secure installation. shelf...
  • Page 6: Wiring Diagrams

    WARNING To replace a light bulb, simply unscrew the bad bulb and replace with a new one. Use only bulbs provided by Eagle Group. These bulbs are specially coated with Teflon to comply with NSF standards and to prevent breakage or possible food contamination.
  • Page 7 RedHots ® Display Light Units WIRING DIAGRAMS...
  • Page 8: Warranty Information

    WARRANTY INFORMATION Limited Warranty for Eagle Products Metal Masters Foodservice Equipment Co Inc. d/b/a Eagle Group or Eagle Foodservice Equipment (“Eagle”) hereby warrants to you, the original purchaser and end-user (“you” or “your”), that the products manufactured by Eagle that you purchased which accompany this Limited Warranty (“products”) shall be free from defects in materials and workmanship under normal use consistent with the accompanying documentation for a period of one year from the date of the original installation of the equipment, not to exceed 18 months from date of shipment from Eagle.

Table of Contents