Advertisement
Prepared (also subject responsible if other)
EAB/FJB/GM Peter Schurmann
BMR46 series PoL Regulators
BMR46 series PoL Regulators
Approved
EAB/FJB/GM [Ksenia Harrisen]
Input 4.5-14 V, Output up to 50 A / 165 W
Input 4.5-14 V, Output up to 50 A / 165 W
Soldering Information - Hole Mounting (SIP version)
The product is intended for plated through hole mounting by
wave or manual soldering. The pin temperature is specified to
maximum to 270°C for maximum 10 seconds.
A maximum preheat rate of 4°C/s and maximum preheat
temperature of 150°C is suggested. When soldering by hand,
care should be taken to avoid direct contact between the hot
soldering iron tip and the pins for more than a few seconds in
order to prevent overheating.
A no-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside the product or between the
product and the host board. The cleaning residues may affect
long time reliability and isolation voltage.
Delivery Package Information (SIP version)
The products are delivered in antistatic trays
Tray Specifications
Antistatic Polyethylene foam
Material
5
10
< Ohms/square <10
Surface resistance
The trays are not bakeable
Bakability
15 mm [ 0.709 inch]
Tray thickness
100 products, 2 full trays/box)
Box capacity
35 g empty tray, 549 g full tray
Tray weight
Ericsson Internal
PRODUCT SPEC.
No.
5/1301 - BMR 464 2002 Uen
Checked
Date
See §1
2013-11-05
11
Technical Specification
Technical Specification
1/28701-BMR 464 Rev.B
1/28701-BMR 464 Rev.B
July 2019
July 2019
Rev
Reference
D
Template rev. J
© Flex
© Flex
1 (3)
76
Advertisement
