Advertisement
Prepared (also subject responsible if other)
EAB/FJB/GM Peter Schurmann
BMR46 series PoL Regulators
BMR46 series PoL Regulators
Approved
EAB/FJB/GM [Ksenia Harrisen]
Input 4.5-14 V, Output up to 50 A / 165 W
Input 4.5-14 V, Output up to 50 A / 165 W
Soldering Information - Hole Mounting (Laydown
version)
The hole mounted product is intended for plated through hole
mounting by wave or manual soldering. The pin temperature is
specified to maximum to 270°C for maximum 10 seconds.
A maximum preheat rate of 4°C/s and maximum preheat
temperature of 150°C is suggested. When soldering by hand,
care should be taken to avoid direct contact between the hot
soldering iron tip and the pins for more than a few seconds in
order to prevent overheating.
A no-clean flux is recommended to avoid entrapment of
cleaning fluids in cavities inside the product or between the
product and the host board. The cleaning residues may affect
long time reliability and isolation voltage.
Delivery Package Information (Laydown version)
The products are delivered in antistatic carrier tape
(EIA 481 standard).
Antistatic PS
Material
7
<10
Surface resistance
The tape is not bakable
Bakeability
56 mm [2.20 inch]
Tape width, W
32 mm [1.26 inch]
Pocket pitch, P
1
13 mm [0.51 inch]
Pocket depth, K
0
381 mm [15 inch]
Reel diameter
130 products /reel
Reel capacity
1.8 kg/full reel
Reel weight
Checked
See §1
Carrier Tape Specifications
Ohm/square
Ericsson Internal
PRODUCT SPEC.
No.
Technical Specification
Technical Specification
5/1301-BMR 464 0002 Uen
1/28701-BMR 464 Rev.B
1/28701-BMR 464 Rev.B
Date
Rev
2013-10-31
B
© Flex
© Flex
2 (4)
75
July 2019
July 2019
Reference
Template rev. J
Advertisement
