Table of Contents
Advertisement
This section describes how to update your ATOMAS-MINI-DUAL to newer firmware versions from the web
application.
1. Navigate to your device's web application using your favorite web browser.
2. Click on the Maintenance tab.
3. Click on the Update button. You will be asked for the firmware update file; please select the .iof file
which was provided by IONODES.
4. You will see the following messages indicating the status of the update:
o Firmware upload in progress... (100%)
Lasts around 95 seconds.
▪
Status LED is green.
▪
o Firmware uploaded. Saving to internal storage... (0%)
Lasts around 45 seconds.
▪
Status LED is flashing red-green.
▪
o Validating and decompressing firmware... (0%)
Lasts around 105 seconds.
▪
Status LED is flashing red-green.
▪
o Firmware ready for installation. Rebooting device... (0%)
Web page will disconnect from device until device has rebooted.
▪
You will be prompted for login once the device is up again.
▪
Lasts around 110 seconds.
▪
Status LED is orange.
▪
o Testing firmware stability... (26%)
Lasts 120 seconds.
▪
Status LED is flashing red-green.
▪
5. Firmware update complete. (100%)
8.6.2 Batch Firmware Update
In order to perform a batch update of multiple ATOMAS-MINI-DUAL devices to newer firmware versions you'll
need to use the ICT (IonConfigTool). The procedure is explained in detail in the ICT user manual. Please check
our website for the latest version.
support@ionodes.com |
https://imaging.ionodes.com
| 1-450-696-1060
53
Advertisement
Table of Contents
Need help?
Do you have a question about the ATOMAS-MINI-DUAL and is the answer not in the manual?