Table of Contents
Advertisement
Starting and Stopping the Power
System
Starting the Power System
Starting Procedure
When you open the driver door and sit on the driver seat,
the instrument panel and touch screen will be powered
on. The door opening and closing status, battery level
and other information will be displayed on the instrument
panel.
1 Depress the brake pedal to enter the READY MODE ;
2 Select D gear, or shift into R gear to reverse.
Note: If the steering wheel cannot be turned after the
vehicle has entered "READY MODE", please exit the
vehicle ensuring the drivers door is fully closed. Once
out of the vehicle, please sit back in the drivers seat
and place the vehicle in "READY MODE" as described
in the "Starting Procedure Section"
Alternative Starting Procedure
If the vehicle is located in an area where there are strong
radio signals causing interference or the smart key battery
STARTING & DRIVING
condition is low, please use the following steps to attempt
to start the car:
1 Place the smart key in the position with the buttons
facing upward - as shown in the illustration.
2 Place the shift lever in P gear, depress the brake pedal
and start the power system.
If the vehicle power system cannot be changed after the
car has left the area of strong radio interference or had
5
159
Advertisement
Table of Contents
