Changing Network Interface Parameters - Kyocera FS-C5015N Advanced Operation Manual

Using the Operator Panel

Changing Network Interface Parameters

2-32
This printer supports TCP/IP, NetWare and Appletalk protocols. In
addition, you can install the optional network interface card in the option
interface slot.
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and AppleTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
• Determine whether to print a network status page when the printer is
turned on
1 Press [MENU].
2
Press or repeatedly until Interface > appears.
3
If the current interface is other than network,
press [OK] ([ENTER]). A blinking question
mark (?) appears.
If the optional network interface card is
installed in the printer, Option will be displayed. The setting procedure is
basically the same even in this case.
4
Press or repeatedly until Network
appears.
5
Press [OK] ([ENTER]) again.
Interface
? USB
Interface
? Network
ADVANCED OPERATION GUIDE
>
>