Kyocera KM-1530 Quick Configuration Manual page 4

IB-2X is a slide-in interface board. It can be installed easily without removing the main board on the
printer or copier.
Remove the screws fastening the expan-
1.
sion interface slot cover to the printer/
copier, then remove the interface slot
cover.
While the wizard is easy to use, this section provides some additional information on locating and
connecting to the printer. Insert the CD-ROM (Kyocera Mita Network Library or Kyocera Mita Software
Library) and select
The printer selection screen will be displayed. Quick Setup will discover printers over either IPX or IP
as long as the protocol is installed on the Windows machine running Quick Setup, e.g., if only IPX is
installed, then Quick Setup will find and display only IPX printers.
If a printer is not displayed on the list, an alternate method for connecting is to enter its Ethernet address
in the space provided. The Ethernet address may be found on the IB-2x status page. If an IP printer is
not on the local segment, then it must also have a correctly configured Default Gateway address, and
the network router(s) must be configured to forward IP broadcasts.
If a printer cannot be found by Quick Setup, (e.g. IPX is not in use and IP broadcasts are not for-
warded), then use a web browser or AdminManager for setup. In a web browser, IP broadcasts are
not necessary since the IP address is entered directly. In AdminManager, specific networks may be
defined for searching. See the Security and Followup Management section for more information on
connecting with a web browser or AdminManager.
Insert the board so that its edges are aligned with
2.
the interface slot rails, then fasten it in place using
the screws removed in step 1.
in the Configuration section.
5