Siemens SITRANS FUS060 Operating Instructions Manual page 69

Pipe diameter (menu 7.1.3.1)
This value represents the average inside diameter of the actual pipe and should only be changed
for SONOKIT.
Note
Large sizes
With nominal diameter settings above DN 2000 the deivce may not work properly.
Roughness (menu 7.1.3.2)
Roughness is the value for the inner pipe surface and should only be changed for SONOKIT.
The range of this value is 0.01 mm to 10.0 mm. The standard Siemens sensors have a roughness
of approximately 0.4 mm.
Pipe material
Smooth plastic pipe
Polished stainless steel pipe
Standard carbon steel pipe
Rusty carbon steel pipe
Concrete pipe
Tracks (menu 7.1.4)
This menu consists of the parameters for the path settings and should only be changed for
SONOKIT. In the following table only the parameters for path 1 are explained. The parameters
for paths 2, 3 and 4 are to be handled equally.
SITRANS FUS060 with PROFIBUS PA
Operating Instructions, 09/2021, A5E02225054-AD
7.7 Sensor parameters (menu 7)
Typical roughness
0.1 mm
0.1 mm
0.4 mm
1 to 2 mm
2 to 5 mm
Functions
69