Troubleshooting By User - Thermo Scientific Fisherbrand GT2 Instruction Manual

Troubleshooting by User

If problems occur other than those listed in this table, the authorized customer service representative must be
contacted.
Failure
message
Overtemperature
Incorrect bucket ID
Unapproved rotor
Rotor ID failure
Lid blocked
Motor overtemp
PCB overtemp
Centrifuge GT 2/2R
Problem with centrifuge
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
Centrifuge does not open.
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
The centrifuge cannot be operated.
The run does not start or the centrifuge
runs down without being braked.
Possible causes and cures
Overheating in chamber.
Check the function of the refrigeration unit.
Clean the air inlet for the condenser.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
Bucket code is undefined for the rotor detected, check
the set points for the given bucket code.
It is permitted to use the current bucket in the rotor
currently mounted.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
Rotor code is not in the rotor table.
It is permitted to use the rotor currently mounted in this
device.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
The rotor could not be identified.
Check to see if the rotor is properly installed.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
Restart the centrifuge.
The emergency lid release enables you to retrieve your
samples.
If an error message appears again, inform Customer
Service.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
Restart the centrifuge.
If an error message appears again, inform Customer
Service.
Troubleshooting | 21