HandyTrac Key Control System Installation & Operating Manual page 17

8. Once the appropriate employee is
selected, tap on Register fingerprint.
10. The system will chime and notify of
a successful read and display the
fingerprint image.
Notes:
• It is recommend you test your fingerprint access by logging out of the HandyTrac system and signing
back in by placing your finger on the reader.
• Badges and PINs can still be used in the event a finger is cut or no longer reads properly.
• Fingerprints are removed when an employee is deactivated on the website.
This concludes initial system setup. General system usage
and website features are detailed on the following pages.
HandyTrac Touch
9. Remove the protective film from the
fingerprint reader and place your finger
on the reader.
11. Repeat until the system says the print is
successfully registered.
User Guide
17