Cylinders - A; Frame - Skyjack SJ1044 TH Manual

Scheduled Maintenance Inspections
Wheel/Tire
Assembly
Lug Nut
1.5-5 Cylinders - A
Ensure all cylinders are properly secured and there is
no evidence of leakage.
Grease weekly and check pins and bushings to ensure
there is no evidence of damage.
Refer to section 5.3 for greasing procedure.

1.5-6 Frame

Wheel/Tire Assembly -
▪
Tire and/or wheel failure could result in a telehandler
tipover. Component damage may also result if
problems are not discovered and repaired in a timely
fashion.
Check all tire treads and sidewalls for cuts or
▪
cracks that expose the cord plies.
Check for punctures, holes and unusual wear.
▪
Check each wheel rim for damage and cracked
▪
welds.
Check each lug nut for proper torque to ensure
▪
none are loose. Refer to section 5.4-1 for torque
procedure.
WARNING
If any tire does not meet the criteria outlined
above, remove telehandler from service and
replace wheel/tire immediately.
SJ1044 TH, SJ1044 THS, SJ1056 TH, SJ1056 THS, SJ1256 THS
Rear Axle
Assembly
A
Frame Level
Cylinder
Front & Rear
Drive Shafts
Air-filled Tires - A
▪
To safeguard maximum stability, achieve optimum
telehandler handling and minimize tire wear, it is
essential to maintain proper pressure in all air-filled
tires. Refer to tire pressure label.
Check each tire with an air pressure gauge and
▪
add air as needed.
WARNING
An improperly inflated tire may cause death or serious
injury.
Foam-filled Tires -
▪
Tire condition can vary significantly depending on
telehandler use, job site environment and preventative
maintenance measures. Inspect tires periodically and
pay extra attention to the following:
Check for punctures or holes. Ensure they do not
▪
exceed 1 inch in diameter.
IMPORTANT
Do not intermix foam-filled and air-filled tires.
Section 1 – Scheduled Maintenance
A
230790ABA
17