Visca Rs-422 (Serial) Connection - Sony RM-IP500 Operating Instructions Manual

VISCA RS-422 (serial) connection

You can connect multiple cameras in a serial connection using the VISCA RS-422 OUT connectors. In a
serial connection, a remote controller can control up to seven cameras. These cables support connection
at distances of up to 1.2 km.
Use a LAN straight cable for RS-422 connection using the RJ-45 connector.
Connecting remote controllers and cameras using serial connection
Connection example
For connection of a single camera to a single remote controller
RM-IP500
For connection of multiple cameras to a single remote controller
RM-IP500
IN
OUT
Notes
• When connecting an SRG-360SHE in a serial connection, only one SRG-360SHE camera can be
connected to a single remote controller.
To connect multiple SRG-360SHE cameras or to mix with other model cameras, use the connection
described in "VISCA over IP (LAN) connection" (page 15).
• The ILME-FR7 does not support serial connection.
Camera with Camera with
RJ-45 connector RJ-45 connector
IN OUT
Remote control signal: LAN straight cable (category 5 or higher)
Camera with RJ-45 connector
Camera with
9-pin connector
23
Camera with
RJ-45 connector
IN
Up to seven
cameras