Checking Camera Settings Status (Status Display); Restoring Factory Default Settings - Sony RM-IP500 Operating Instructions Manual

Checking Camera
Settings Status (Status
Display)
Press an assign button (ASSIGN 1 to ASSIGN 3)
with the camera status display function
assignment to display the current iris, gain,
shutter speed, and zoom position status of the
target camera on the LCD panel for about three
seconds.
Note
This function is not supported for the ILME-FR7.
After approximately three seconds, the display
automatically turns off.
ZOOM position indicator

TELE
WIDE
 represents the divisions between the WIDE
and TELE positions, while  represents the
current position from the WIDE end.
 indicates Clear Image Zoom and the digital
zoom range. The indicator changes from  to 
when the camera zoom is in that range.
Restoring Factory
Default Settings
You can restore all settings stored in the unit to
their factory default values.
This operation is performed using MAINTENANCE
>RESET in the RM menu.
1
Press the RM MENU button, turning it on
(button is lit yellow).
The RM menu top menu appears.
2
Turn the SELECT knob to move the cursor
to MAINTENANCE.
3
Press the SELECT button.
The MAINTENANCE menu appears.
4
Turn the SELECT knob to select RESET.
The RESET screen appears.
5
Turn the SELECT knob to move the cursor
to RESET ALL.
     
6
Turn the VALUE knob to change NOT EXEC
to EXEC, then press the VALUE button.
The following message appears, prompting
you to reboot the unit.
7
Turn the VALUE knob to change NO to YES,
then press the VALUE button.
The unit reboots automatically.
62