Unit Assembly - U-Line H-9652 Quick Start Manual

PAGE 2 OF 15

UNIT ASSEMBLY

1.
Figure 1
2. Secure legs to undershelf with set screws using 5/32"
Figure 2
3. Stand table upright and place tabletop onto legs,
Set Screw
Gusset
Figure 3
4. Level table with the adjustable feet. Adjustable feet
Figure 4
NOTE: If purchased with optional casters,
adjustable feet will be replaced after complete
table assembly.
With the undershelf on its side, push the legs through
the collars to the desired height. To ensure exact
height, mark desired height on each leg with magic
marker or grease pencil. (See Figure 1)
NOTE: Each leg must be at the same height or
shelf collars could fail. Recommended height
from the floor to the top of the undershelf is 10"
and must be 6" or higher to meet NSF standards.
NOTE: Optional casters add 3⁄" to height.
Allen wrench. (See Figure 2)
NOTE: Undershelf must be level. Use care not to
overtighten screws or failure will occur.
inserting legs into tabletop gussets. With a 5/32"
Allen wrench, tighten set screw on each gusset.
(See Figure 3)
allow approximately 1" of adjustment. (See Figure 4)
0922 IH-8966