Table of Contents
Advertisement
neighbouring live parts;
•
Select suitable tools, measuring equipment and, if necessary,
personal safety equipment;
•
Evaluation of measuring results;
•
Selection of electrical installation material for safeguarding
shut-off conditions;
•
IP protection types;
•
Installation of electrical installation material;
•
Type of supply network (TN system, IT system, TT system)
and the resulting connecting conditions (classical zero
balancing, protective earthing, required additional measures
etc.).
To install the DHC Floor Heating Controller into a power distribution
panel it has to be mounted in accordance with VDE 0603, DIN
43871 (low-voltage sub-distribution board), DIN 18015-x. In this
case, the installation must be made on a mounting rail (DIN rail)
according to EN50022. Installation and wiring have to be performed
according to VDE 0100 (VDE 0100-410, VDE 0100-510 etc.). Make
sure to consider the technical connection requirements (TAB) of
your energy supplier.
Observe the hazard information in „2 Hazard information" on page
8 during installation.
Start-up
15
Advertisement
Table of Contents
Need help?
Do you have a question about the homecontrols EKRUFHT61V3 and is the answer not in the manual?
Questions and answers