Dynatronics Dynatron 850 Plus Service Manual page 63

Dynatron
• The default power display
2
is W/cm . If you change
the display to WATTS
during use, the machine
reverts to the W/cm
display when the machine
is turned off and on again.
However, if you save
ultrasound default settings
while using the WATTS
display, the WATTS
display will become the
default display for your
machine.
• You can tell when you have
selected WATTS display
by the decimal in the
display window.
- A steadily-lighted decimal means the power is displayed in W/cm
- A blinking decimal means the power is displayed in WATTS.
850plus & 550plus
®
A non-blinking decimal = Power displayed in Watt/cm
A blinking decimal = Power displayed in Watts
2
START
STOP
PAUSE
FUNCTION
Press and hold the PAUSE/FUNCTION key for
two seconds. The machine will beep once to
indicate you have changed the display.
Dynatron 850plus Power Display. You can view
power in either W/cm
Treatment Instructions - ULTRASOUND
55
POWER-INTENSITY
2
or WATTS.
2
.
2