Table of Contents
Advertisement
Novomatics Manual
4.
Installations
4.1.
Instrument installation
The Turbitronic P is an automatic test instrument for desktop use. It includes all required
mechanic and electronic components and requires no installation experience.
When the Turbitronic P is put into operation, the following three connections must be made:
1.
The main cable for power supply. Please note, always an earth connection is available
at the wall socket.
2.
The USB cable between Turbitronic P and your Windows computer.
3.
The two water hoses for outer water circulation. Connect these to a water tap (inlet)
nearby and water drain (outlet). Open the water tap when operating the instrument. Close
it when not needed to prevent any water leakage in operator's absence. If unfortunately
closed the instrument is not damaged but cooling times can be much longer. The water
flows only when cooling is needed so that water consumption is low.
When the connections have been made, the equipment can be switched on by the main switch
on front panel. If the self test proceeds without any failure the light of the ready led is
illuminating after two seconds.
Turbitronic P
7
Advertisement
Table of Contents
