Change The Passcode - novomatics Turbitronic P Operation Manual

Novomatics Manual
5) Now passcode is needed. Enter passcode by setting digit by digit, use up/down buttons
for digit setting and enter button for going to next digit, the first passcode after leaving
factory is 444444
6) After successful setting the new operation mode is blinking for 2 seconds

12.2. Change the passcode

The operation is save only with unknown passcode. That's why the passcode should changes
at next supervisor's opportunity. Please note that passcode can be changed only when the
instrument is in the Lab mode.
1) Press Sel button twice for entering into edit menu
2) Press up/down buttons till the word code is shown.
3) Press the enter button, co000000 is shown and the first 0 is blinking now
4) Enter actual passcode by setting digit by digit, use up/down buttons for digit setting and
enter button for going to next digit, the first passcode after leaving factory is 444444
5) When accepted cn000000 is shown and the first 0 is blinking now
6) Enter new passcode by setting digit by digit, use up/down buttons for digit setting and
enter button for going to next digit
7) When successfully entered the the new passcode is blinking for 2 sec.
Turbitronic P
23