Table of Contents
Advertisement
DOS Printing Utilities
Status Display Screen
The following describes each of the buttons and the commands on the
Status Display
Setup
Set Display Mode Command (Setup Menu)
In the dialog that appears when you execute this command, click the
checkbox next to the
on (checked) and off (unchecked). When this feature is turned on, a dialog
box will appear to alert you whenever an error condition occurs.
• When a popup error message occurs, correct the problem and then
click
OK
.
• You can control which error conditions cause popup error mes-
sages to appear by using the procedure under "Change Popup
Message Command" below.
Change Hot Key Command (Setup Menu)
The dialog that appears when you execute this command shows the
current hot key combination that launches the Status Display. While
the dialog is open, you can change the hot key combination by pressing
the key you want to change.
Change Popup Message Command (Setup Menu)
The dialog that appears when you execute this command contains a list
of error conditions that cause popup error messages to appear. Error
conditions marked
they occur, while no message appears for conditions marked
To toggle an error condition between
and then press
Enter
4-64
menu.
Enable Popup
setting to toggle popup error messages
cause a popup error message to appear when
Active
.
Active
and
Inactive
.
Inactive
, highlight it
Advertisement
Table of Contents
