Alc Ii Diagnose Mode - Alimak ALC II User Manual

ALC II Diagnose mode

To enter diagnose mode:
– Disconnect the battery.
– Turn main power switch in OFF position.
– Push and hold the SNL button.
– Turn main power switch in ON position.
– When DIAGNOSE is on – release the SNL button.
– Reconnect battery.
To exit DIAGNOSE mode: Push the SNL button.
Changing VALUE, use UP or DOWN push button. (Value 16 – 31 = flashing value).
VALUE: Floor indicator
0 –
1 Floor
2 Speed
3 Car S1 type
4 Car S2 type
5 Car #S1
6 Car #S2
7 Base S1 type
8 Base S2 type
9 Base #S1
10 Base #S2
11 DC voltage
12 DC voltage
13 Battery voltage
14 Battery voltage
15 Base-Car error
16 –
17 System temperature
18 System temperature
19 Temperature stop
20 CAN2 rx
21 CAN1 rx
22 Pulse decoder cnt.
23 Z-Pulse decoder cnt.
24 Number of Z error
25 Second
26 Car Input
27 Car Input
28 Car Exp. Input
29 Car Exp. Input
30 Base Input
31 Base Input
Number of floor.
Number of speed.
(0=None, 1=I/O, 2=Call, 3=Keyboard, 4=Car I/O)
(0=None, 1=I/O, 2=Call, 3=Keyboard, 4=Car I/O)
Number of card installed on expander bus (X15=10 ribbon-cable).
Number of card installed on Comm. Control Bus (X3=6-pole).
Same as above but for Base.
Internal voltage.
Internal voltage.
Internal battery voltage.
Internal battery voltage.
Number of Base-Car error.
Internal temperature.
Internal temperature.
If the unit have reached temperature max (65°C) counter.
Can communication line 2.
Can communication line 1.
Decoder pulse count.
Decoder pulse count.
Decoder error count.
Second counter.
Input in hex value.
Input in hex value.
1:st connected card in loop with
10-part connector connection.
1:st connected card in loop with
6-part wire connection.
ALIMAK 35077 - 1/12
(The integer part)
(The decimal)
(The integer part)
(The decimal)
(0–31)
(The denary part)
(The unit part)
(0–31)
(0–31)
(0–31)
(0–31)
(230VAC X14:1–4)
(X11.1–X11.6)
(230VAC X14:1–4)
(X11.1–X11.6)
(X0)
(X3)
A
17