Configuration & Menu Settings; Initial Setup; Switching Modes - Yada BT532981 User Manual

CONFIGURATION & MENU SETTINGS

Initial Setup

Set the date & time before installing and using the Roadcam. This date &
time is the time stamp for all recorded media files and digital clock.

Switching Modes

Press the
camera mode > playback mode. The Roadcam cannot switch between
modes while it is recording. Press the
press the
Video Mode
• This is the default recording setting. The Roadcam will start recording
automatically once it is turned on.
• Files are looped or recorded over by the default of 1 minute.
The MicroSD card will hold 1 minute segments and record over them as
space is needed.
• Stop loop video: press the
• Lock video: press the
• Press and hold the
on or off.
Note: The Roadcam will record automatically when you switch back
to video mode from other shooting modes.
G-Sensor Setting The Roadcam's integrated G-Sensor will
automatically save and lock the recorded file if activated by an impact
event or accident. Select to adjust the G-Sensor sensitivity level, or to turn
it on or off. The default setting is low.
10
button to cycle through the following modes: video mode >
button to switch between modes.
button during recording to lock that recorded file.
button during recording to turn the microphone
button to stop recording and then
button once to start or stop recording.