List Of Messages - Canon XA60 Instruction Manual

Troubleshooting
Connections with External Devices
Video noise appears on a nearby TV screen.
- When using the camcorder in a room where a TV is located, keep a distance between the USB
power adapter and the power or antenna cables of the TV.
Playback looks fine on the camcorder but there is no image on the external monitor.
- The camcorder is not connected correctly to the external monitor. Make sure the camcorder is
connected correctly (A 108).
134
- The video input on the external monitor is not set to the video terminal to which you connected
the camcorder. Select the correct video input.
The camcorder is connected using the optional HTC-100 High Speed HDMI Cable, but there is
no picture or sound from the external monitor.
- Disconnect the High Speed HDMI cable and then restore the connection or turn the camcorder
off and then on again.
- The connected monitor is not compatible with the selected video configuration. Change the
video configuration to one that the monitor supports.
There is no image on the connected computer.
- The USB cable is connected to the camcorder's DC IN terminal. Connect the USB cable to the
USB terminal.
The computer does not recognize the camcorder even though the camcorder is connected
correctly.
- Connect the camcorder to the computer only while the photo index screen is displayed.
- Disconnect the USB cable and turn off the camcorder. After a short while, turn it on again and
restore the connection.
- Connect the camcorder to a different USB port on the computer.
Cannot transfer MP4 clips and photos to the computer.
- The SD card contains too many MP4 clips and photos. Delete some recordings (A 103) until
the SD card contains a combined total of 2,500 (Windows)/1,000 (macOS) or fewer recordings.

List of Messages

Accessing the memory card. Do not remove the memory card.
- You opened the SD card compartment cover while the camcorder was accessing the SD card
or the camcorder started accessing the card as you opened the SD card compartment cover.
Do not remove the SD card until this message disappears.
Back up recordings regularly
- This message may appear when you turn on the camcorder. In the event of a malfunction,
recordings may be lost so back up your recordings regularly.
Battery communication error.
- You attached a battery pack that is not recommended by Canon for use with this camcorder.
- If you are using a battery pack recommended by Canon for use with this camcorder, there may
be a problem with the camcorder or battery pack. Consult a Canon Service Center.
Battery pack is not compatible. Turning off the camcorder.
- A battery pack not recommended by Canon for use with this camcorder was attached and the
camcorder was turned on. The camcorder will automatically turn off in 4 seconds.
Cannot play back
- Clips cannot be played back from a 512 MB or smaller SD card. Use a compatible SD card
(A 30).
(in alphabetical order)
Does this battery display the Canon logo?