Canon XA60 Instruction Manual page 118

Menu Options
[Conversion Lens]:
Wide Attachment, set the appropriate conversion lens setting. The camcorder will then optimize the
image stabilization and adjust the minimum object distance. The minimum object distance throughout
the entire zoom range will be 130 cm (4 ft. 3 in.) for the tele-converter and about 60 cm (2 ft.) for the
wide attachment. When you select [¿ WA-H58] and you zoom in, the zoom position marker will
stop before reaching the end of the zoom bar.
• The tele-converter increases the focal length by a factor of approximately 1.5 while the wide
118
attachment decreases it by a factor of approximately 0.75.
• When you select a setting other than [j Off], the AF mode is automatically set to [@ Normal
AF].
• The approximate focusing distance displayed on the screen will change depending on the setting. If
you are not using an optional conversion lens, select [j Off].
[Powered IS Button]:
(A 66).
[Î Press and Hold]: Powered IS will be activated while you hold the button pressed down.
[Ï Toggle On/Off]: Each press of the button will turn the Powered IS function on and off.
[Set WB Priority]:
frequently. You can press an assignable button set to [
current white balance and the white balance setting selected for [Set WB Priority].
[Focus/Zoom Ring
[Focus Ring Direction]:
This setting affects the focus/zoom ring only when using it to adjust the focus (when the focus/zoom
ring switch is set to FOCUS).
[Focus Ring Response]:
ring. This setting affects the focus/zoom ring only when using it to adjust the focus (when the focus/
zoom ring switch is set to FOCUS).
[Zoom Ring Direction]:
adjust the zoom (when the focus/zoom ring switch is set to ZOOM).
[IR Light]:
Turns the infrared light on and off. The light is located on the handle unit so make sure you
attach it to the camcorder in advance.
• If set to [i On], the infrared light is always on when the camcorder is in infrared mode.
[É Playback Setup] menu (
Menu item
[¸ Data Code]
[ Data Code],
[{ Data Code]
[Data Code]:
For clips, displays the date a clip was recorded. For photos, displays the date and/or time
or camera setting used when a photo was recorded.
When you attach to the camcorder the optional TL-H58 Tele-converter or WA-H58
Determines the operation mode of the assignable button set to [È Powered IS]
Convenient for times when you need to use a particular white balance setting
Operation]:
Selects whether to enable or disable the focus/zoom ring's operation.
Changes the direction the focus/zoom ring needs to be turned when focusing.
Selects the sensitivity of the response when focusing using the focus/zoom
Changes the direction the focus/zoom ring needs to be turned when using it to
mode only)
[j Off], [% Date]
[j Off], [% Date], [& Time], [
Data] (XF-AVC clips) or [{ Camera Data] (photos)
WB Priority] to switch between the
Setting options
Date and Time], [
y }
–

Camera
 
A
–