Routine Cleaning And Maintenance - HAMPTON BAY Greenfire GCi60-2 Owner's Manual

Cast iron pellet insert

Hide thumbs Also See for Greenfire GCi60-2:

Technical manual (40 pages)

Table Of Contents

Table of Contents

The following list of components should be inspected and maintained routinely to ensure that the appliance is

operating at its optimum and giving you excellent heat value. The appliance, flue gas connector and the chimney

flue require regular cleaning. Check them for blockage prior to re-lighting after a prolonged shut down period.

Weekly

Burn Pot and Liner - Empty

Agitator

Heat Exchanger Tubes

Door Glass

Ash Pan and Door Gaskets

Inside Firebox

Door Latch

IMPORTANT : The purchaser is responsible for the annual maintenance of the Appliance, as outlined in the

owner's manual. The warranty may be voided due to problems caused by a lack of maintenance. Records/receipts of

all maintenance completed by service companies must be kept in case asked for if there is warranty on the product.

BURNER POT AND LINER (Checked Daily/Emptied Weekly)

This is the 'pot' where the pellets are burned. Only clean when the unit is cold.

Note: If, after long periods of burning, the fire continually builds up and overflows the burn pot or there is a build

up of clinkers, this is an indication that the pellet fuel quality is poor or the stove may need cleaning. Check the

stove for ash build up (clean if required) and adjust the slider / damper to produce the proper clean combustion.

1. Open the door using the door handle located on the right-hand side of the stove.

2. Lift the lever on burn pot to unlock the fire grate and remove it.

3. The agitator locks at the right; rotate the top of the agitator towards the back of the firebox to unlock it, slide

it to the left, and lift it out of the burn pot liner.

4. Lift the burn pot liner out of the stove.

5. Lift the burn pot from the firebox by gently lifting it up at the front of the burn pot, then slide it out from around

the air intake tube and the ignitor cartridge.

6. Remove any build up on the agitator (calcium build-ups are common

when burning corn). Using a metal scraper, remove material that

has accumulated or is clogging the liner's holes and dispose of the

scraped ashes from the liner and from inside the burn-pot.

7. Place the burn-pot back into the stove, there are hooks at the front

of the burn pot that sit in a mount in the firebox. Ensure that the air

intake tube and the ignitor cartridge are properly inserted into the

burn pot.

8. Place the liner back into the burn-pot, making sure that the ignitor

hole in the liner is aligned with the ignitor tube.

9. Slide the agitator back into place and turn rotate the top towards

the front of the stove to lock it in.

10. Set the fire grate in place, it should sit level on the front and back of

the burn pot liner. Lock it in with the lever on the burn pot.

11. Close the door.

Hampton GCi60-2 Cast Pellet Insert Owner's Manual