Message Listing - Kodak i800 Series Quick Reference Manual

Message Listing

Following is a list of messages and corrective actions you can take if one of the
following messages appears on the Operator Control Panel. Most corrective
actions can be found in the Multi-media User's Guide for the Kodak i800 Series
Scanners.
Calibrate scanner now
You must calibrate the scanner now.
Calibration failed
Perform a controlled power-down sequence; recalibrate the scanner. Be sure
you are using the correct calibration target.
Clean imaging guides
The imaging guides are dirty.
Clean the S1 sensor
The S1 (pre-imaging ) sensor is dirty.
Clean the S2 sensor
The S2 (post-imaging ) sensor is dirty.
Control panel button depressed
A Control Panel button is stuck in the engaged position.
Document jam
Clear the paper path.
Error; Reset Scanner
Try turning the scanner on and off again. If error persists, call service.
Image buffer almost full
Processing will resume when the buffer is less full.
Image buffer full
Image data has been lost. Clear the documents and rescan.
Interlocks are open
One of the doors is not closed.
Lamps not stable
Calibration was attempted before the lamps were warmed up.
No paper in tray
Place paper in elevator tray and restart.
Replace lamps now
Replace all four lamps now.
S1 sensor is blocked
Check for a document jam.