Wine Guardian DS050 Quick Start Installation Manual page 5

3. Installing Thermostat (Wired) — continued
G. Re-attach the front cover plate to the back plate by
screwing it into place.
H. Connect RJ-9 cable to the back of the remote user
interface and attach to the wall at the screw
locations.
I. Reconnect RJ-9 cable to side of the Wine Guardian
unit at either COM1 or COM2.
Note: For wireless installations or multiple
remote interfaces, refer to the full version manual
located at wineguardian.com/manuals
4.
Condensate Drain
A. Wine Guardian ducted systems are supplied with 7
feet (2 meters) of ½" (13 mm) inside dimension clear
tube.
NOTE: Wine Guardian units have an internal trap. Do
not double trap piping. Failure to comply may lead to
water leaks and possible water damage to surround-
ing mounting area. Install drain line with a ¼ inch per
linear foot (1.25 cm/linear meter) of pitch.
5.
Installing Ductwork
A. The split units are supplied with one (1) supply duct
collar and (1) return duct collar as standard
equipment.
B. Install ductwork by folding back the insulation to
expose the wire reinforced vinyl duct. Slip the
ductwork over the end of the duct collar and fasten
using two tie wraps supplied with the kit making sure
the ductwork is tight on the duct collar.
C. Fold the insulation back over the duct and duct collar
and secure to collar using duct tape.
D. Reconnect cable to side of fan-coil unit at either
COM1 or COM 2.
5