Pioneer XV-DVR9H Operating Instructions Manual page 51

Recording
• Ttl Name Input – Optionally, you can enter a name
for the recording up to 32 characters. (Highlight
Program Set then press
this option.)
5 After entering all the timer recording
information, highlight 'Program set' and press
ENTER.
The timer recording list screen is displayed again. The
timer program you just input appears in the list. The
rightmost column shows various timer recording status
messages:
• Standby is displayed when the recorder is in timer
recording standby.
• Recording is displayed when a timer recording is in
progress.
6 To exit the timer recording screen, press HOME
MENU.
Note
• For a DVD timer recording, if Optimized Rec (see
Optimized Rec on page 111) is set to On (and VPS/
PDC is off), the recorder will adjust the recording
quality to try and fit the recording on the disc. If the
recording will not fit onto the disc even on MN1
recording quality then the Recovery Recording
feature will automatically make the recording to the
HDD instead.
• If there is very little free space left on the HDD, an
Auto Replace Recording may not complete
successfully.
• If the HDD is being used for playback or high-speed
copying when an Auto Replace Recording is due to
start, the new timer recording will not replace the old
one. However, the next time the timer recording
starts, both of the older two programs will be erased.
• If you set the timer recording to use VPS/PDC, you
must switch the system into standby before the timer
recording is due to start for it to work correctly. For
non-VPS/PDC timer recordings there is no need to
switch the system into standby.
Tip
• Stations that use VPS/PDC typically include VPS/
PDC information in the teletext TV guide pages.
Please refer to these when setting your timer
recording.
(cursor down) to access
Timer recording using the VIDEO Plus+
programming system
This system makes programming timer recordings very
simple. Most TV guides publish PlusCode programming
numbers with their program details. If you want to make
a timer recording of a program, you just input the
corresponding code. The date, start, stop and channel
settings are made automatically. All you have to do is tell
the system the recording mode, and whether it's a once-
only recording or a regular recording.
Note that the system must be in DVD/HDD mode in order
to use this feature.
HDD DVD
VIDEO Plus+
HOME
MENU
®
CLEAR
ENTER
NAVI MARK
06
51
En