Pioneer XV-DVR9H Operating Instructions Manual page 47

Recording
• If the DVD/HDD is stopped, you can also use the –/
+/
buttons on the front panel to select the
channel number.
3 Use the REC MODE button to set the picture
quality/recording time.
• See Setting the picture quality/recording time on
page 46 for detailed instructions.
4 Use the AUDIO button to select the audio
channel to record.
See Changing audio channels on page 22 for more on
this.
• When recording in VR mode, if a broadcast is
bilingual, both audio channels are recorded, allowing
you to switch the audio channel on playback. The
only exception to this is when the picture quality is set
to FINE/MN32, in which case you do need to select
the audio channel before recording.
Press ì REC to start recording.
5
If you want to set a recording end time, press the ì REC
button repeatedly. The recording time increases in 30
minute increments, up to a maximum of six hours. The
time the recording will end is shown on-screen and in the
front panel display. When the recording ends, the system
automatically switches into standby if the input function
is set to DVD or HDD and no other operation is being
performed.
• To cancel the set recording time, press ì REC.
• If you want to pause recording at any time, press
PAUSE. Press again to restart the recording. (If
recording to the HDD or in VR mode, a new chapter
is started after recording restarts)
• You can change the input function (to FM/AM for
example) during recording without affecting the
recording.
6 To stop the recording, press
• If you set the recording time in the previous step,
you can still stop the recording anytime by pressing
STOP REC.
• Recording will stop automatically when there is no
more space on the HDD/DVD, or after six hours of
HDD recording (whichever is sooner).
• You can only stop recording when the input function
is set to DVD or HDD.
Tip
• During recording you can turn on/off the SCART loop
through function. During recording, press the front
panel +/ button to switch to SCART THRU (loop
through on), or –/ to switch to SCART NORM
(loop through off). Note that you can't switch loop
Direct recording from TV
If you connected this system to your TV using a SCART
cable, and your TV supports Direct Recording, you can
record whatever is currently being shown on the TV
without having to worry about what channel this system
is set to. Check the instructions that came with your TV if
you're not sure whether your TV supports this feature.
1
2
The function automatically switches to HDD/DVD.
If you want to set a recording time, press the ì REC
button repeatedly. The recording time increases in 30
STOP REC.
minute increments, up to a maximum of six hours. You
can see the recording time on-screen and in the front
panel display. When the recording ends, the system
automatically switches into standby if no other operation
is being performed.
• To cancel the set recording time, press ì REC.
• If you want to pause recording at any time, press
3
• If you set the recording time in step 2, you can still
• Recording will stop automatically when there is no
through on if recording from the AV2(LINE 1/
DECODER) or AV1(RGB)-TV connectors. Also, loop
through is automatically reset to off after recording
has finished.
PAUSE
REC STOP REC
ì
If necessary, load a recordable disc.
Press TV DIRECT REC to start recording.
PAUSE. Press again to restart the recording. (If
recording to the HDD or in VR mode, a new chapter
is started after recording restarts)
To stop the recording, press
stop the recording anytime by pressing
more space on the HDD/DVD, or after six hours of
HDD recording (whichever is sooner).
TV/DVD
TV DIRECT REC
STOP REC.
STOP REC.
06
47
En