Video In / Out Settings - Pioneer XV-DVR9H Operating Instructions Manual

15 The Initial Setup menu

Video In / Out settings

Input Colour System
• Default setting: Auto
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
On the default setting, the system automatically detects
whether the video signal from the built-in tuner or from
one of the external inputs is PAL, SECAM, 3.58 NTSC or
PAL–60. You may, however, occasionally need to set it
manually if the picture is not displayed properly.
1 Select 'Input Colour System', then 'Next Screen'.
2 Use the CHANNEL +/– buttons or the INPUT
SELECT button to switch between the built-in tuner
and the external inputs.
3 Use the
change the input colour system for the current input
or built-in tuner.
• The available settings depend on the Input Line
System setting (see Input Line System on page 102).
The table below shows the different options available.
Input Line System
625 System
525 System
106
En
Input Colour System Next Screen
AV1 Out
AV2/L1 In
NTSC on PAL TV
(cursor left/right) buttons to
Pr 5
Auto
Built-in tuner External input
Auto Auto
PAL PAL
SECAM SECAM
n/a Auto
3.58 NTSC
PAL–60
AV1 Out
• Default setting: Video
Important
• If you make a setting here that is incompatible with
your TV, the TV may not display any picture at all. If
this happens reset the system (see Resetting the
system on page 124 for how to do this).
Initial Setup
Basic Input Colour System
Tuner AV1 Out
Video In/Out AV2/L1 In
Audio In NTSC on PAL TV
Audio Out
Language
Recording
Playback
• Video – Compatible with all TVs, but lowest quality of
the three settings.
• S-Video – Almost the same quality as RGB, but can
give better results if you are using a long SCART
cable.
• RGB – If your TV is compatible, this setting gives the
best picture quality.
Note
• You may have to set up your TV for a specific video
input type. Check the operating instructions for your
TV for more information.
AV2/L1 In
• Default setting: Video
You only need to make this setting if you connected this
system to another component using the AV2(LINE 1/
DECODER) AV connector.
Initial Setup
Basic Input Colour System
Tuner AV1 Out
Video In/Out AV2/L1 In
Audio In NTSC on PAL TV
Audio Out
Language
Recording
Playback
The AV2(LINE 1/DECODER) connector input can be set
to one of the following settings. Match the setting to that
output from the connected component.
• Video – Sets the input signal type to composite
video.
• S-Video – Sets the input signal type to S-video.
• RGB – Sets the input signal type to RGB video.
Video
S-Video
RGB
Video
S-Video
RGB
Decoder