Audio Out Settings - Pioneer XV-DVR9H Operating Instructions Manual

15 The Initial Setup menu
Bilingual Recording
• Default setting: A/L
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
When recording a bilingual source from an external input
in Video mode or VR mode set to FINE/MN32, or to the
HDD, you can choose to record either the A/L (left), or
the B/R (right) audio channel.
Note
• If you're recording in VR mode (except when set to
FINE/MN32), both channels will be recorded and you
can switch them as you like on playback.
DV Input
• Default setting: Stereo1
You need to set this if you have a camcorder using 32kHz/
12-bit sound connected to the front panel DV IN/OUT jack.
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
Some digital camcorders have two stereo tracks for
audio. One is recorded at the time of shooting; the other
is for overdubbing after shooting.
On the Stereo1 setting, the sound that was recorded
while shooting is used. On the Stereo2 setting, the
overdubbed sound is used. You can also choose a Mix
setting of 25%, 50% or 75% for the Stereo 1 with a
corresponding Stereo 2 setting of 75%, 50% or 25%.
Input Level (L1 / L2)
• Default setting: 0dB
Initial Setup
Basic
Tuner
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
108
En
NICAM Select A/L
Tuner Level B/R
External Audio
Bilingual Recording
DV Input
Input Level (L1)
Input Level (L2)
NICAM Select Stereo1
Tuner Level Stereo2
External Audio Mix (Stereo1: 75%)
Bilingual Recording Mix (Stereo1: 50%)
DV Input Mix (Stereo1: 25%)
Input Level (L1)
Input Level (L2)
NICAM Select +6dB
Tuner Level +3dB
External Audio 0dB
Bilingual Recording – 3dB
– 6dB
DV Input
Input Level (L1)
Input Level (L2)
You can adjust the gain of the audio from the L1 and L2
SCART inputs individually, from –6dB to +6dB in steps of
3 dB to optimize the recorded audio level.
See also Analog audio attenuator setting on page 124 if
you need to adjust the audio input level of the ANALOG
AUDIO inputs.

Audio Out settings

You only need to change these settings if you connected
this system to another component using the optical digital
output. Changing these settings will also affect the sound
you hear through the speakers of this system
Dolby Digital Out
• Default setting: Dolby Digital
Initial Setup
Basic Dolby Digital Out
Tuner 96kHz PCM Out
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
If the connected component is Dolby Digital compatible,
set to Dolby Digital, otherwise set to Dolby Digital
PCM. Check the manual that came with the connected
component if you're unsure whether it is Dolby Digital
compatible.
96kHz PCM Out
• Default setting: 96kHz
Initial Setup
Basic Dolby Digital Out
Tuner 96kHz PCM Out
Video In/Out
Audio In
Audio Out
Language
Recording
Playback
If the connected component is compatible with high
sampling rate audio (88.2 / 96 kHz), set to 96kHz,
otherwise set to 96kHz 48kHz. Check the manual that
came with the connected component if you're unsure
whether it is compatible with high sampling rate audio.
Dolby Digital
Dolby Digital PCM
96kHz 48kHz
96kHz