Advertisement
12 x Short Bolts
16 x Washers
(H8)
(H7)
1 x Allen Key
4 x Long Bolts
(H9)
(H14)
4 x Levelling Feet
2 x Connectors
(H10)
(H13)
Stick 2 x Felt Pads (H21) to the centre of each connector (H13).
2 x Felt Pads
(H21)
Align and position 4 x Legs (H6) onto the pre-drilled holes on the Bottom
Panel (P2). Align and position the 2 x Connectors (H13) between the
Legs (H6) as shown ensuring the side with the Felt Pads (H17) is on the
Bottom Panel (P2).Using 3 x Washers (H7) and 3 x Short Bolts (H8), secure 1 x Leg (H6) to
the Bottom Panel (P2), tightening using the Allen Key (H9).
Secure the Connector (H13) to the Table Leg (H6) and Bottom Panel (P2)
using 1 x Washer (H7) and 1 x Long Bolt (H14), tightening using the Allen Key (H9).
Attach 1 x levelling foot (H10) to one leg (H6) and tighten by turning clockwise.
Repeat this step for the other 3 x Legs (H6).
6 x Dowels
6 x Cam Bolts
(H1)
Phillips Head
Screwdriver
Insert 6 x Dowels (H3) into Bottom Panel (P2) and secure 6 x Cam Bolts (H1)
to Unit Bottom Pane l(P2) by tightening with the Phillips Head Screwdriver.
H10
H13
(H3)
(P2)
H9
H8
H14
H7
H7
H17
H17
H13
Advertisement
