General settings
7.4.2
Scraper blades
A
Figure 7.13
The machine is delivered with standard type scraper
blades (A).
Wider points (B) may be ordered. The part number for
these points is indicated in the spare parts manual.
The wider point is designed for clay soils and moist
conditions with little occurrence of straw, e.g. when
working in very moist, ploughed clay soil.
7.4.3
Middle section
Figure 7.14
The scrapers on the centre section can be adjusted
lengthwise by repositioning the scraper unit in the oblong
holes in the holders under the frame.
1. Loosen the bolted joints (A) and adjust to the desired
position.
2. Tighten the bolted joints.
28
7.4.4
B
Figure 7.15
Figure 7.16
1. The scrapers on the wheel sections can be adjusted by
2. Retighten the nut.
A
7.5
7.5.1
The hydraulics system should be synchronised before any
adjustments are made. See "9.6.1 Synchronising the
series-connected hydraulics system"
Wheel section
A
turning the tube along the groove in the holder.
Loosen the nut (A) and set to the desired position.
Front tools
CrossBoard
903815-en-gb; 23.09.2021