Block Diagram; Wise-4051; I/O Specification - Advantech WISE-4000 Series User Manual

2.7.4

Block Diagram

2.8

WISE-4051

2.8.1

I/O Specification


Digital Input
– Channel: 8
– Logic level
–Dry Contact 0: Open
–Wet Contact 0: 0~3 V
–Channel 0~3 should be configured to dry contact or wet contact in the same
time
–Channel 4~7 should be configured to dry contact or wet contact in the same
time
– Isolation: 3,000 V
– Supports 32-bit Counter Input Function (Maximum signal frequency 3 kHz)
– Keep/Discard Counter Value when Power-off
– Supports Frequency Input Function (Maximum frequency 3 kHz)
– Supports Inverted DI Status

RS-485 Port
– Number of Ports: 1
– Port Connector: 3.5mm spacing plug-in screw terminal block (shared with I/O
and power)
– Baud Rate (bps): 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200
– Data Bits:7, 8
– Stop Bits: 1, 2
– Parity: None, Odd, Even
– Flow Control: Auto flow control
– Signals: DATA+ and DATA-
– Protection: 15 kV ESD
– Supported Protocol:
–Modbus/RTU (Total 32 address by max. 8 instructions)
Figure 2.26 WISE-4050 Block Diagram
1: Close to DI COM
or -3~0 V
DC DC
1: 10~30 V or -30~-10 V
DC
rms
29
(3 mA min.)
DC
WISE-4000 User Manual