Switch; Led Definition - Advantech WISE-4000 Series User Manual

1.5

Switch

Switch
SW1
SW2
SW3
Note 1 After the position 1 of SW1 been changed, user need to power on the
module again to apply the operation mode
Note 2 SW2 is for WISE-4051, WISE-4050(/LAN), and WISE-4060(/LAN), all 4
channels have to be configured to dry contact or wet contact in the same
time, and both P1 and P2 have to be changed together
Note 3 SW3 is for WISE-4051 only, all 4 channels have to be configured to dry
contact or wet contact in the same time, and both P1 and P2 have to be
changed together
1.6

LED Definition


WISE-4000 Wireless Series
LED
Status
Com
AP/Infra
Signal
Strength

WISE-4051 Only
LED
Tx
Rx

WISE-4000/LAN Series
LED
Status
Com
Link
Speed
WISE-4000 User Manual
Description Position
P1
Operation Mode
P2
P1
DI Type
(Ch0~3)
P2
P1
DI Type
(Ch4~7)
P2
Color Indication
Blink
Green
ON 30 Sec
Yellow Blink
ON
Green
OFF
ON *4
ON *3
Green ON *2
ON *1
All OFF
Color Indication
Yellow Blink
Green Blink
Color Indication
Blink
Green
ON 30 Sec
Yellow Blink
Green ON
Yellow ON/OFF
ON (Default)
Normal Mode
N/A
Dry Contact
Dry Contact
Dry Contact
Dry Contact
Behavior
2Hz: Wait for connection
0.5Hz: Network Connected
When enable LOCATE function.
When TX/RX data in transmission
Limited AP Mode
Station Mode
Full Signal
Good Signal
Okay Signal
Poor Signal
No Signal/ Limited AP Mode
Behavior
RS-485 port is transmitting data
RS-485 port is receiving data
Behavior
Module is normally at work. (1Hz)
When enable LOCATE function.
When TX/RX data in transmission
Both ends of devices are connected
ON: 100 Mbps
OFF: Less than 10 Mbps
6
OFF
Initial Mode
N/A
Wet Contact
Wet Contact
Wet Contact
Wet Contact