Table of Contents
Advertisement
Once the configuration is completed, the
instrument will be in a paused ('interrupted') state
and, therefore, will require prompting from the
user to set it running. This can be achieve in one
of 3 ways:
1. Select the RUN button in the instrument tab of
DataLog X2 (See image).
2. Enter the command #028 in the Terminal
window.
3. Disconnect, then reconnect the
Power/Comms cable to activate the
instrument.
4.2.3 Download a File
The download wizard is shared with DataLog X2, it operates in the same way as in Terminal with
the addition that any downloaded files are automatically loaded into the
Clicking on the download icon invokes the
Download Wizard. As with all wizards the first
stage is to identify the connected insturment
and comms settings.
Ensure the instrument is switched on and
connected. Extend the interrupt timeout if the
unit is operating in burst mode (or cycle the
power to the instrument)
Page | 25
DataLog x2 and Terminal x2 Installation and User Guide
File
Manager.
MANUAL-1899207337-17
© 2021 – Valeport Ltd
Advertisement
Table of Contents
