Table of Contents
Advertisement
Section 3 | Terminal X2
Once the configuration is completed, the
instrument will be in a paused ('interrupted')
state and, therefore, will require prompting from
the user to set it running. This can be achieve in
one of 3 ways:
1. Select the RUN button in the instrument tab
of DataLog X2 (See image).
2. Enter the command #028 in the Terminal
window.
3. Disconnect, then reconnect the
Power/Comms cable to activate the
instrument.
3.4 Download a file
Clicking on the download icon invokes the
Download Wizard. As with all wizards the first
stage is to identify the connected insturment and
comms settings.
Ensure the instrument is switched on and
connected. Extend the interrupt timeout if the
unit is operating in burst mode (or cycle the
power to the instrument)
© 2021 – Valeport Ltd
Page | 12
Advertisement
Table of Contents
