KitchenAid KBNU361VSS Installation Instructions And Use & Care Manual page 15

4. Install the tank tray mounting brackets to the base or floor of
the island using the proper size and type of mounting
hardware (not supplied). Tighten mounting hardware.
A
B
C
3"
(7.6 cm)
A. Screw (Use proper screw for island floor material.)
B. Lock washer
C. Flat washer
5. Pre-adjust each of the bottom nuts on the mounting brackets
to 3" (7.6 cm) from the base of the island to the top of the
nuts.
6. Remount the tank tray back onto the mounting brackets.
Replace the 4 top nuts, but do not tighten.
A
B
C
D
A. 20 lb LP gas fuel tank
B. Tank tray for 20 lb gas fuel tank
C. Top nut (do not tighten)
D. Mounting bracket
7. The tank tray for the 20 lb LP gas fuel tank must be adjusted
so that the bottom of the tank tray is
cabinet door opening and is level. The top nut on each of the
mounting brackets is to be loose. Turn the bottom nuts
counterclockwise to raise the tank tray and turn the bottom
nuts clockwise to lower the tank tray. When the tank tray is
level and slides in and out without touching the cabinet door
opening at the bottom or top with the 20 lb LP tank installed,
tighten the top nuts against the adjustment flange.
A
A. Top nut loosened
B. Top nut tightened
NOTE: A bracket or shelf (not supplied) that is large enough
to keep a second 20 lb LP gas fuel tank from being stored in
the storage area under the grill is required to be mounted
inside the island. Bracket dimensions are shown for
reference.
11 "
(30 cm)
2 "
(6.8 cm)
8. Plug in the electrical connector from the back of the grill to
the electrical connector from the 20 lb LP gas fuel tank tray.
A
A. Electrical connector from 20 lb LP gas fuel tank tray
B. Electrical connector from back of grill
NOTE: These connectors must be plugged in for the
electronic control "Fuel Remaining" feature to work for use
with a 20 lb LP gas fuel tank.
" (0.32 cm) above the
B
6"
(15.2 cm)
21" (53.3 cm) for 48" (121.9 cm) doors
9" (22.9 cm) for 36" (91.4 cm) doors
B
15