Startup / Operation - BOMANN VS 2185.1 Manual

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
"Cleaning and Maintenance"
the chapter
Starting the appliance
• Connect the appliance to the power supply.
• Set the operating conditions. See also the follow-
ing sections.
Settings
Position [ 0 ] means that the appliance is in the
switched-off state. Turn the temperature control
clockwise from this position, the appliance switches
on automatically.
The power levels control the different values of the
internal temperature.
Power level
lowest level → warmest internal
1, 2
temperature
medium level → optimal operating
3, 4
temperature
highest level → coldest internal tem-
5, 6, 7*
perature
*Beware of high setting because the maximum level may
already mean "freezing point".
Basically, the temperature changes depending on the
ambient temperature (place of installation), the fre-
quency of opening the door and the equipment.
For initial operation, first set the lowest possible inter-
nal temperature (= highest power level) until the ap-
pliance has reached the desired operating tempera-
ture. It is recommended to reset to a medium power
level afterwards, then you can easily make any tem-
perature correction.
Recommendation, for optimized food storage and to
avoid food waste, a medium power level is generally
best. A high power level also increases energy con-
sumption.
The recommended temperature in the center of the
.
appliance is approx. 4∼7 degrees. If the temperature
in the center is correct, the different zones usually
also have the correct temperature.
Interior light
When opening the appliance door, the interior light
will turn on automatically.
Equipment
Note that the equipment varies depending on the ap-
pliance type.
The various shelves and drawers can be height-ad-
justed (partially and model-dependent) or removed
for individual storage. Practical also for cleaning pur-
poses.
NOTE:
For the most efficient use of energy, place all
shelves/drawers in their original positions.
Removing / inserting the shelves
• To remove, open the unit door completely, lift the
shelf, if necessary, slant slightly and pull it out to
the front.
21