Appliance Equipment; Installation - BOMANN VS 2185.1 Manual

• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and Maintenance"
according to chapter

Appliance Equipment

Appliance Overview
1 Temperature control /
interior light
2 Glass shelves
Delivery scope
3x glass shelf, 1x vegetable box, 3x door storage
rack, 2x egg tray, 1x rubber supporting pad

Installation

Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 50～70 mm, to the
-
side walls and above the appliance each ap-
prox. min. 100 mm;
Place the appliance so that the appliance door
-
can open without being impeded.
.
3 Vegetable box
4 Feet
5 Door storage racks
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under
Data"
and on the rating label located in the interior
or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the rubber supporting pad
CAUTION:
Under extreme circumstances, there is a risk that the
appliance may tilt forward.
NOTE:
Installation of the rubber supporting pad is ONLY
necessary if the interior is empty and the refrigerator
door is loaded with 15 kg or more.
Tilt the appliance slightly back and block it in this po-
sition. Use the delivered screw to secure the support-
ing pad into the hole provided on the underside of the
door.
19
"Technical