Startup / Operation - BOMANN KSG 7282.1 Instruction Manual

Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
• Remove the plastic rivet (1) and hinge cover (2).
• Loosen the screws (3) and remove the door hinge
(4). Lift the unit door from the door hinge (6).
• Displace the dummy plug (5) of the appliance
door. Place the appliance door safely aside.
• Tilt the unit slightly backwards and block it in this
position.
• Disassemble the lower door hinge (6) incl. foot by
loosening the screws (7). Unscrew the separate
foot (8).
• Displace and fasten the door hinge (6) incl. foot
with the screws (7) accordingly. Screw in the sep-
arate foot (8).
• Return the unit to the upright position. Place the
appliance door on the hinge pin and fix it in the in-
tended position.
• Displace and fasten the upper door hinge (4) with
the screws (3) accordingly.
• Put the plastic rivet (1) in the exposed hole and
replace the hinge cover (2).
screw wrench, Phillips screw-
Check that the door is aligned vertically and horizon-
tally to ensure proper opening and closing of the
door.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for approx. four hours before connecting to
the power supply. Nonobservance could lead to mal-
function of the cooling system and causes an appli-
ance breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
section "Settings".
Settings
The power levels [ 1 – 5 ] regulate the different val-
ues of the internal temperature.
Setting 1 Lowest setting (warmest inside temp.)
Setting 5 Highest setting (coldest inside temp.)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the appliance loading.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
medium setting; correcting the temperature at a later
point would then be easier.
17