Advertisement
Quick Links
Sch. 1156/10
Keypad programming guide
Note there are NO DEFAULT CODES in the 1156/10 keypad and
Urmet do not have any record of the Engineer's Password.
If you do not know the Engineer's Password then it will be
necessary to gain access to the rear of the keypad
Advertisement
Related Manuals for urmet domus 1156/10
Summary of Contents for urmet domus 1156/10
- Page 1 Sch. 1156/10 Keypad programming guide Note there are NO DEFAULT CODES in the 1156/10 keypad and Urmet do not have any record of the Engineer’s Password. If you do not know the Engineer’s Password then it will be necessary to gain access to the rear of the keypad...
- Page 2 There are two possibilities when programming the 1156/10 keypad; 1. You know the Engineer’s Password (six digits). In this case the keypad can be programmed without being removed from its housing. See Page 2 2. You do not know the Engineer’s Password.
- Page 3 Use the following procedure to enter a new Door Open Code or change the existing Door Open Code - Press then enter the Engineer’s Password and press (BEEP BEEP BEEP). Press again (BEEP BEEP BEEP). Enter the relay time (door open time). E.g. for 5 seconds press 5 or for 10 seconds press 10 BEEP BEEP BEEP).