Advertisement
Assembly Instructions
Steam Roller D375, D376, D377 & Traction Engine D415, D416, D417
Stage 2, Burner chamber, rear
Illustration 5
20
1x burner chamber cover
21
1x control cabin
22
1x steering shaft bracket
23
1x clutch lever
24
1x tow bar
5
10x hexagonal nuts M3
4
8x slot bolts M3x4mm
25
2x slot bolts M3x6mm
26
1x burner chamber rear wall
Text & illustrations: Wilesco Wilhelm Schröder GmbH & Co., Germany
Assembly Instructions
Steam Roller D375, D376, D377 & Traction Engine D415, D416, D417
Stage 3, Burner chamber front
Illustration 6
Fit the tow bar (24) to the control cabin (21) with 2
slot bolts (4) M3x4mm and nuts (5). The two slot
bolts (25) M3x6mm are inserted at the top of the
burner chamber cover (20) and secured with 2 nuts
(5). At a later stage the piston cylinder plate is fitted
to these screws.
The rear wall of the burner chamber (26) is fitted to
THAT end of the cover, which has the hole on top
for the steam whistle. Then the steering shaft
bracket (22) is fitted to the right hand side of the
cover and driver's cabin, with 2 slot bolts (4)
M3x4mm and nuts (5), using the second and fourth
hole from the bottom. The steering shaft bracket
has to be mounted between the rear wall of the
burner chamber and the control cabin (see
illustration 6). Secure the burner chamber rear wall
at the bottom.
Illustration 7
Insert on the left hand side the clutch lever (23) into
the second and fourth hole from the bottom with 2
slot bolts (4) M3x4mm and secure with 2 nuts (5).
On completion, all screws should be checked for
tightness.
Advertisement
