Advertisement
Assembly Instructions
Steam Roller D375, D376, D377 & Traction Engine D415, D416, D417
Stage 1, Front Part Steam Roller
Illustration 1
1
2 x front rollers
2
1 x saddle cam
3
1 x saddle
4
4 x slot bolts M3x4mm
5
4 x hexagonal nuts M3
6
1 x roller bracket
7
6 x washers 8/4.5mm
8
1 x front axle diameter 4x116mm
9
1 x scraper harness
10
2 x spacers, red diameter 6x24mm
11
4 x slot bolts M2x6mm
12
4 x hexagonal nuts M2
Illustration 3
Fit the scraper harness (9) with 2 slot bolts (11)
m2x4mm and nuts (12), each side. Insert screws
from either top or bottom and tighten well.
Stage 1, Front Part Traction Engine
Illustration 2
Push the two front rollers (1) onto the front axle (8).
The pressing nearer the roller-edge faxes
outwards. Push on both sides of the front axle (8)
washers (7) then a red spacer (10). Assembly of
front axle with rollers in the wheel bracket (6). The
play between wheel bracket and the front rollers is
adjusted by means of washers (7) so that the front
rollers move easily.
Illustration 4
The saddle cam (2) is fitted with 4 slot bolts (4)
M3x4mm and nuts (5) onto the saddle (3).
This front part is put to one side and connected
with the boiler in stage 8.
Advertisement
