Illustration 31
Place the spring of the steering chain into the
scraper harness on the left hand side. Using a
strong piece of string for tensioning purposes. Pull
the right hand spring and locate into scraper
harness.
Text & illustrations: Wilesco Wilhelm Schröder GmbH & Co., Germany
Illustration 31a ONLY FOR TRACTION ENGINES
The vertical shaft on the front wheel bracket from
Stage 1 is placed from underneath through the hole
in the cap (similar to illustration 30). The two small
holes in the wheel bracket must point rearwards.
The safety cap (19) is placed onto the taper and
pushed home.
The photo (illustration 31a) shows the underneath
of the traction engine. Place the springs of the
steering chain from underneath into the small holes
of the wheel bracket. The steering is complete now.