Advertisement
Illustration 27
81
1 x steering column with pinion
82
1 x worm with chain and springs
19
1 x safety cap diam. 4 mm
83
1 x steering wheel
84
1 x spacer, chrome long
34
2 x washers diam. 6.7/3 mm
4
1 x slot bolt M3 x 4 mm
5
2 x hexagonal nuts M3
85
1 x spacer, chrome short
86
1 x crown wheel
Illustration 29
Now the steering worm is fitted. The chain is wound
on both sides around the worm, one side to the left,
the other side to the right. The worm (82) is placed
into the bracket and secured on the right hand side
with crown wheel (86) and slot blot (4). Tighten
securely!
Illustration 28
The steering column (81) is fitted with the short
spacer (85) with the collar pointing upwards. Then
it is pushed from underneath through the gangway
bracket and the steering bracket. The long spacer
(84) is pushed onto the top of steering column. Fit a
nut (5) and a washer (34). The steering wheel (83)
is pushed over the column and secured by means
of a washer (34) and a hexagonal nut (5). Tighten
firmly!
Illustration 30 ONLY FOR STEAM ROLLERS
The vertical shaft on the front wheel bracket from
Stage 1 is placed through the saddle cam and is
secured with the locking cap (19) in such a way
that the holes of the scraper harness (9) point
forwards.
Advertisement
