Operating Modes; Measuring Modes - DAK 900-EH Series Manual

Operating Modes

There are 4 types of operating modes. They are as follows:
1. Idle / Default Mode – This is the default/ stand by mode of the Densimeter.
2. Density Measuring – This mode is used for measuring the density of the specimen.
3. Gen Set Mode – This mode is used for changing the various settings in the Densimeter.
4. Calibration Mode – This mode is used for calibration of the Densimeter before taking the readings of the
samples.
5. Configuration Menu – This mode is used for configuring Alloy mixtures values, temperature compensation
etc

Measuring Modes:

There are 5 types of measuring modes. They are as follows:
1. Solid Density – The density of solid material can be measured in this mode.
2. Liquid Density – The density of liquid can be measured in this mode.
3. Alloy 1 Density – The density of any mixture can be measured in this mode.
E.g.: Considering A as mixture of B & C. Density of A, B & C can be measured.
Thus this can also be used for detecting the purity of the sample for which the test is been performed.
4. Alloy 2 Density – The density of any mixture can be measured in this mode.
5. Alloy 3 Density – The density of any mixture can be measured in this mode.
6. REF. MEM. MODE.
To Change Measuring mode:
1. From Idle mode keeping "A" pressed, click "B" Key till you reach your desired mode of measurement.
2. Subsequent presses will change the measuring mode in rotation.
__________________________________________________________________________________ 9