Set Time & Date; Re-Print Result - DAK 900-EH Series Manual

SET TIME & DATE
Importance: This option can be used to set the Date and time of operation which in the Idle mode can also be used
as a Digital Table Clock.
- After entering the Gen Set Menu
- Select "SET TIME & DATE"
- Press "Enter"
- The cursor appears under the Date digit, use keys "A" or "B" to change the numbers, to shift the cursor to the
Month digit press "Tare" and enter digits using the same process as date to change the number and press
"Tare" again for shifting the cursor to the Year digit and use keys "A" or "B" to change the numbers for
entering the year.
After setting the Date, press "Enter" and you will automatically go to the Time setting menu.
- Enter hours
- Enter minutes
- Enter seconds like date was entered
- This in the Idle mode can also be used as a Digital Table Clock.

RE-PRINT RESULT

- This function is to re-print the last obtained result when print settings are in the Manual Mode
- After entering the Gen. Set Menu
- Select "RE-PRINT RESULT"
- Press "Enter" to re-print the last result.
*Note: This option will be enabled only if "Print" option above is Enabled.
*Kindly note: All the measurements, including the calibration process should be done with the Windshield
On the equipment to ensure no atmosepheric disturbance and accurate results. The images in this manual
are shown without the shield to give a closer view of the process.
__________________________________________________________________________________ 16